Setup; Installing The Ceiling Hoist To The Rail System; Installing Robin; Installing Robin® Mover - Invacare Robin Manuel De Maintenance

Invacare® Robin®

3 Setup

3.1 Installing the ceiling hoist to the
rail system
Robin® requires a trolley, guiding the ceiling hoist in the
rail system. Robin® Mover has the trolley built-in and can
be installed directly to the rail system.
3.1.1 Installing Robin®
Tools: 4 mm Allen key; 17 mm socket wrench
1. To install the trolley, remove the end stop that is
attached to the rail system.
In some countries/ local areas, there is a
demand for double securing of the end stops.
If an extra securing screw is installed, remove
this screw first.
2. Insert the trolley into the rail (no matter which way,
as the trolley is symmetric).
3. Re-insert the end stop.
In some countries/ local areas, there is a
demand for double securing of the end stops.
If an extra securing screw is required, install
this screw. See also End Stop.
4. Locate the hoist trolley at the Ø 32 mm round recess
in the rail.
5. Lift the hoist and push the suspension pin through
the trolley opening.
6
6. Turn the hoist by 90 degrees to fix it in the trolley.
7. Connect the hand control.
8. Adjust the length of the emergency stop/lowering cord
to within the user's reach.
If there is excessive resistance, or if the trolley
unintentionally rolls by itself due to imbalance in
the rail suspensions, adjust the friction brake using
a 4 mm Allen key.
3.1.2 Installing Robin® Mover
The trolley is built-in on the hoist, and can therefore not
be pre-installed in the rail.
Tools: 4 mm Allen key; 17 mm socket wrench
1. Remove the end stop.
2. Insert the wheels of the hoist into the rail.
The direction the hoist faces does not matter
during installation.
3. Install the end stop.
Tighten the bolt to 30 Nm.
1586747-E