Technical Data; The Rail System; Dimensions And Weight; Electrical System - Invacare Robin Manuel De Maintenance

Invacare® Robin®

8 Technical Data

8.1 The rail system

All rail profiles are manufactured in extruded aluminium.
The rails are available with white powder coating.
The rails are available in three different heights; S= 68
mm, M=114 mm and L=183 mm, providing a fee span of 2
m, 4 m and 8 m, respectively.
The profile width of all three profiles is 58 mm. The top of
the profiles are shaped to permit the coupling of the rails
to the installation brackets.
On delivery, the rail for the hoist will feature a milled
groove on its bottom. This groove is used for hoist
installation and is called keyhole.
Possible installations
Single rail can be installed on the ceiling or onto the wall
and floor. The rail position in the room can be either
parallel to a wall or angular in relation to a wall.
The traverse system can be installed on the ceiling or onto
the wall and floor. The free span between the two parallel
rails can be up to 8000 mm.
Curves are available in the S-profile and can be installed
on the ceiling. They are available in angles of 30°, 45°,
60° and 90°.
Special solutions
Installation with pendling brackets is used in the following
cases: When the height of the ceiling varies in the
lengthwise direction of the rail, or when the rail is to be
countersunk.
Angular installation is used when the rail has to be
installed in other angles than 90°.

8.2 Dimensions and weight

Dimensions
Hoist length (A)
Hoist width (B)
Hoist height (C)
Maximum lifting range (D)
22
Robin®
Robin®
Mover
470 mm 470 mm
250 mm 250 mm
203 mm 266 mm
2.5 m 2.5 m
Weights
Maximum lifting capacity
(Safe Working Load)
Total weight without sling

8.3 Electrical System

Robin®
Maximum
current input
Protection class 1
(ceiling hoist: IP24; hand control: IP44)
Insulation class
Applied part complying with the
specified requirements for protection
against electrical shock according
Sound level
Number of lifts
65 lifts of 0.5 m with 80 kg
per charge
Intermittent
(periodic motor
10%, max. 2 min. / 18 min.
operation)
Battery
NiMH Battery 24 V / 1.9 Ah
Charging time
Lifting speed
2.1 cm/s
with 200 kg load
Traverse speed in
the tracks
Charger
During charging: 25 – 36 V DC
Voltage output
100 – 240 V AC, 50 – 60 Hz
Voltage supply
Protection class
1 IP41 or IP67 (depending on version)
1 See product label and label on each electric device
for correct protection class. The lowest IP classification
decides the overall classification of the device.
• IPx4: Protected against water splashed from any
direction.
• IP24: Protected against objects larger than 12.5
mm and protected against water splashed from any
direction.
• IP44: Protected against objects larger than 1 mm and
protected against water splashed from any direction.
• IP41: Protected against objects larger than 1 mm and
protected against vertically dripping water.
• IP67: Dust-tight and protected against temporary
immersion into water.
Robin®
Robin® Mover
200 kg 200 kg
7.3 kg 10 kg
Robin® Mover
0.9 A
Entire device: IPx4
Class II equipment
Type B applied part
to IEC60601-1.
50 – 55 dB (A)
Up to 3 hours at 20°C
2.1 cm/s
n/a 14 cm/s
No-load: 41 V DC
1586747-E