Hach LANGE EVITA OXY Manuel D'utilisation page 102

USC 7000 multidrop system
Change transmitter address
So that the USC 7000 can detect the transmitter via the HART
clear address value between 1 and 15 must be assigned to the
transmitter. The transmitter EVITA
setting 0, which is used for point-to-point installations (USC 5000).
For the programming of the address of a new transmitter connect this to
the USC 7000 and select with the keys of the USC the menu item "Scan
HART bus" (Figure 21, page 102.) The next available address between
1 and 15 is assigned to the new transmitter.
Note: If before the access to the HART
address value that is over 0 has been registered as interrupted for longer
than two minutes, this address is assigned to the new OXY transmitter.
Figure 21 Transmitter address
Password
0000.
10.64 mg/l
Oxygen
Transmitter 0
Temperature
Transmitter 0
42. d
Calibration
Transmitter 0
12. d
No. of alarms
Transmitter 0
72. h
Rem. lifetime
Transmitter 0
Reset lifetime
Transmitter 0
Last calibration
Transmitter 0
Error pending
USC
Scan HART bus
Scan HART bus
Are you sure ?
English 102
®
OXY is supplied with the default
®
bus an OXY transmitter with an
®
USC
Settings
TR. 0 TR. 0 TR. 0
Settings OXY Basic settings Advanced settings
Ser.No. SSSSVVNUUÅ
TR. 0
Set transmitter
address 00
USC USC
Scan HART bus Trm. address 0
Busy changed to 05
Setup of the oxygen- and temperature units and of the
current output of the transmitter
If required the default settings can be changed as shown below.
bus, a
The setup of the display- and current output for oxygen- and
temperature measurement device is done via "Basic Settings". The
setup of the transmitter measurement range for the oxygen content is
done via change of the values 4 mA and 20 mA.
Otherwise the setup of the measurement range of the oxygen- and
temperature measurement unit is done as shown in
and in Figure 24, page
Figure 22 Transmitter settings
Figure 23, page 103
104.