Stihl FSA 60 R Notice D'emploi page 18

English
1
2
3
► Position the unit so that you are facing the
underside of the deflector and the drive shaft
is pointed upwards.
► Slip the thrust plate (2) onto the drive shaft (3),
keeping the side of the thrust plate with the
smaller diameter facing upwards toward the
mowing head (1).
► By hand, screw the mowing head (1) clock‐
wise onto the drive shaft while holding the fan
wheel (4) with your other hand.
► Continue screwing down the mowing head
until it is securely tightened.
NOTICE
■ Using the trimmer with overly long trimmer line
increases the load on the motor and reduces
its operating speed. This may result in over‐
heating and damage to important components.
12.4.2 Removing a Mowing Head
Mowing head AutoCut C 6-2
To remove a AutoCut C 6-2 mowing head:
► Switch off the power tool,
► Remove the battery,
► Position the unit so that you are facing the
underside of the deflector and the drive shaft
is facing upwards.
► Block the rotation of the drive shaft by holding
the mowing head with your hand.
► Unscrew the mowing head by turning the cap
counterclockwise.
Mowing head PolyCut 6-2
To remove a PolyCut 6-2 mowing head:
► Switch off the power tool,
► Remove the battery,
► Position the unit so that you are facing the
underside of the deflector and the drive shaft
is facing upwards.
► Block the rotation of the drive shaft by holding
the mowing head with your hand.
► Unscrew the mowing head by turning the
upper part counterclockwise.
18
1
4
15.2.
14.2
15.2.
14.2
Mowing head DuroCut 5-2
To remove a DuroCut 5-2 mowing head:
► Switch off the power tool,
► Remove the battery,
► Position the unit so that you are facing the
underside of the deflector and the drive shaft
is facing upwards.
► Block the rotation of the drive shaft by holding
the fan wheel with your hand.
► Unscrew the mowing head by turning it coun‐
terclockwise.
► Remove the thrust plate.
13 Adjusting the Trimmer
13.1 Adjusting the Loop Handle
The loop handle can be mounted to suit the
height and reach of the operator.
To adjust the position of the loop handle:
► Switch off the power tool,
► Remove the battery,
a
3
► Loosen the screws (2) that attach the loop
handle to the trimmer shaft.
► Slide the loop handle (1) to the desired posi‐
tion, subject to the following limitations:
– Always keep the spacer (3) positioned
between the loop handle and the control
handle.
– The distance marked "a" must be less than
11.8 in. (30 cm).
► Tighten the screws until the loop handle is
secure and can no longer be moved along the
drive tube.
13 Adjusting the Trimmer
15.2.
14.2
15.2.
14.2.
1
2
0458-832-8221-B