Technical Data; Residual Risks; Before Starting The Equipment - Scheppach Air Force 4 Traduction Des Instructions D'origine

6.

Technical data

Mains connection
Motor rating W
Operating mode
Compressor speed
min
-1
Operating pressure
Theoretical intake
capacity (l/min)
Sound power level L
Uncertainty K
WA
Protection type
Protection class
Weight of the unit in kg
The noise emission values were measured
in accordance with EN ISO 3744.
Wear hearing protection.
The effects of noise can cause a loss of
hearing.
7.

Residual risks

Comply with the stipulated maintenance
and safety instructions in the operating in-
structions.
Remain attentive at all times when working
and keep third parties at a safe distance
from your work area.
Even when the device is being used proper-
ly, there will always be certain residual haz-
26 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
220 - 240 V~
50 Hz
max. 1100
S3 15%
4300 min
-1
approx. 8
bar
approx. 180
97 dB(A)
WA
1.93 dB
IP20
II
5
ards that cannot be completely ruled out.
The following potential hazards can arise
due to the type and design of the device:
• Unintentional starting up of the product.
• Damage to hearing if the stipulated
hearing protection is not worn.
• Dirt particles, dust etc. can get into the eyes
or face despite wearing safety goggles.
• Inhaling swirled up particles.
8.

Before starting the equipment

Before you connect the equipment to the
mains supply make sure that the data on the
rating plate are identical to the mains data.
• Check the equipment for damage which
may have occurred in transit. Report any
damage immediately to the transport
company which was used to deliver the
compressor.
• Install the compressor near the point of
consumption.
• Avoid long air lines and supply lines (ex-
tension cables).
• Make sure that the intake air is dry and
dustfree.
• Do not install the compressor in a damp
or wet room.
• The compressor may only be used in
suitable rooms (with good ventilation
and an ambient temperature from +5 °C
to 40 °C). There must be no dust, acids,
vapors, explosive gases or inflammable
gases in the room.
• The compressor is designed to be used
in dry rooms. It is prohibited to use the
compressor in areas where work is con-
ducted with sprayed water.