Festo DGPI- -AIF Série Notice D'utilisation page 29

DGPI(L)−...−AI F
7 Commissioning
Commissioning the complete system
Slowly pressurize the complete system.
S
In this way you will prevent sudden un
controlled movements.
For slow start−up pressurization, use
safety start−up valve type HEL−.../HEM−... .
Commissioning the DGPI(L)−...
Warning
S Make sure that:
nobody can place his/her hand in the path
of the moveable mass (e. g. by providing a
protective grill).
there are no objects in its path.
It must not be possible to touch the
DGPI(L)−... until the mass has come to a
complete stand.
Control with SPC11/200:
1. Note the stroke reduction per end position.
Only limited positioning behaviour is available
within the stroke reduction.
DGPI(L)−...
Cushioning length d
Stroke reduction r
At the factory it is intended that the pneumatic end position cushioning is
open completely on both sides when the device is controlled by the
SPC11/200.
Festo DGPI(L)−...−AIF 0409a English
25 32 40...80
18 mm 20 mm 30 mm
25 mm 25 mm 35 mm
HEL−...
QH−...
Fig. 17
Fig. 18
d
Fig. 19 r
29