Hach MET ONE 3411 Manuel D'utilisation page 16

Particle counter navigation
The functions of the particle counter are accessed from the Counter
Navigation screen. Table 1 shows the functions that are accessible
through the navigation screen.
Table 1 Icons - Counter Navigation screen
Icon Function Description
Sample Measure particle counts. Refer to
counts on page 16.
Historical Review measurement results in the buffer; print, export
or filter data. Refer to the expanded manual on the
manufacturer's website.
Export Output file as PDF, comma separated value (CSV), tab
separated, XML or PortAll files. Refer to the expanded
manual on the manufacturer's website.
Printer Print sample data as hard-copy. Refer to
Print Center
Test wizard Test and report wizard for ISO, EU-GMP, FS or BS
classification compliance. Refer to the expanded manual
on the manufacturer's website.
Locations Add/edit/remove areas; copy location settings, edit
locations settings; edit alarms for specific locations.
Refer to the expanded manual on the manufacturer's
website.
Group Load/add/edit a group; delete a group. Refer to the
expanded manual on the manufacturer's website.
System Time/Date; Sleep time/backlight timeout; set logon
requirements; set sounds for alarms; manage users; set
the units for flow rates; manage the data buffer. Refer to
the expanded manual on the manufacturer's website.
16 English
Measure particle
How to use the
on page 17.
Table 1 Icons - Counter Navigation screen (continued)
Icon Function Description
Diagnostics View diagnostic information for troubleshooting. Refer to
Diagnostics and Troubleshooting
Network Configure the network and communication settings.
Factory View the factory information including the calibration
date.
Operation
Log on to the particle counter
Prerequisites
• Start the system.
1. Activate the backlight with a finger or stylus if needed.
2. Push the icon to log out a previous user. Push
logon screen.
3. Enter the user name and password. Confirm.
Note: Push the ALT key to access special characters.
Measure particle counts
After a complete particle count measurement, the number of
particles measured will show on the screen and be stored as data. Other
configured parameters, such as relative humidity, temperature and air
velocity will be shown and stored in data.
1. Remove the protective cap from the inlet tube on the counter.
2. On the Counter Navigation screen, push SAMPLE.
on page 19.
again to see the