Hach MET ONE 3411 Manuel D'utilisation page 13

Assemble the particle counter system
Figure 4 shows how to assemble the particle counter system.
Figure 4 Particle counter assembly
1 Remote installation of the probe
1
Shown with the optional isokinetic probe stand.
Install the printer paper
N O T I C E
To avoid damage to the printer, do not operate the printer without paper. Use
only the recommended thermal paper. If the particle counter must be used
without paper, be sure to set the print mode to "None".
1
2 Local installation of the probe
Refer to the illustrated steps in Figure 5
Figure 5 Printer paper installation
to install printer paper.
English 13