Publicité
Les langues disponibles
Les langues disponibles
FOR SINGLE INSTALL:
INSTALL ANTI-TIP DEVICES
1. Remove hole covers from the top of product.
2. Install the anti tip brackets to the top of the product
with screws E from accessory bag. Make sure backets
are lined up.
If attaching the anti-tip bracket to
the adjacent cabinet follow above
illustration.
3. Align the brackets with the cabinetry and gently push the
product into the cabinet opening to the desired depth.
Note: If you have trouble to push the unit all the way
into the cabinet hole, you may have tangled power cord
at the back. To avoid it, remove 3 plastic clips from
accessory bag and install them on to the top 3 screws
location of access cover with the original access cover
screw. Put cord into 3 clips. Plug the cord into outlet
and tie a string or a wire in the middle of cord between
plug and last clip where a white mark is. You can either
use the wire from accessory bag or any string you have.
Thread the string or wire through the 1st clip then pull
the string or wire over the unit while you push the unit
into the cabinet hole. Adjust the string releasing position
and make sure the appliance will be completely nested
in cabinet hole. Then release the string.
String
28
Installation Instructions
Screw
holes for
countertop
attachment
If attaching the anti-tip
bracket to the countertop
follow above illustration.
JOIN DUAL INSTALL
Included installation materials and parts in
Unification Kits ZKAW and ZKN48W. Kits are
sold separately.
Top/bottom
Front Trim Piece
(Front Connector) x 1
connectors×2
Anti-sweat foam ×1
Dimension:
18-1/8" x 1-5/16" x 9/16"
(460mm x 846mm x 15mm)
Fastener C
1. Make sure the two products to be unified have the door
swings adjusted to have both handles in the middle and
doors opening outward away from each other.
2. Remove paper from adhesive strip on the anti-sweat
foam piece and install on the product case side of one
of the unified products. Either product is acceptable.
Make sure you place the foam at least 10mm from
appliance cabinet front.
Anti-sweat foam
3. Align the two cases to a gap of approximately 1/2"
(13 mm). This will leave a gap of approximately 5/32"
(3.75 mm) between the door panels.
Anti-sweat foam
Back
connector×3
Toe Kick x 1
Fastener E
49-1000777 Rev. 2
Publicité
