USING THE BEVERAGE CENTER
GLASS SHELVES
Tempered glass shelves in the beverage center unit are
removable for easy cleaning or for storing larger items.
To remove a shelf, open the door completely to avoid
potential damage to the gasket. Lift up on the back of the
shelf slightly. Tilt the shelf to one side at an angle while
pulling forward.
Appearance may vary
To remove, lift up on the back of
the shelf
QUICKSPACE
™
SHELF
This shelf splits in half and slides under itself for storage
of tall items on the shelf below.
Step 1: Lift the front edge of the front half of the shelf.
Step 2: Lower the back edge of the front half of the shelf
while sliding it underneath the back half.
The entire Quick Space shelf can be removed and
replaced (see Glass Shelves section).
49-1000777 Rev. 2
To replace a shelf, open the door completely to avoid
potential damage to the gasket. Tilt the shelf to one side
at an angle and slide toward the back wall, placing one
side onto the shelf support. Place the other side onto
the opposite shelf support. Ensure rear locking tabs are
engaged. When installed properly, the shelf will not slide
forward when gently pulled.
Tilt the shelf at an angle while
removing or replacing
Place in slots when replacing the
shelf
Step 1
Step 2
15