Publicité
Les langues disponibles
Les langues disponibles
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
—
and ordinances. Save these instructions for local
inspector's use.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Beverage center Installation
can vary
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING
EXCESS WEIGHT HAZARD
Use two or more people to move and install beverage
center. Failure to do so can result in back or other injury.
CAUTION
Contact with sheet metal or other exposed material edges can result in personal injury. Installing product may create
pinch points.
Wear gloves and protective clothing when installing this product.
Item
Tools
1
Right angle drive
2
Wrench
3
Allen wrench
4
Wrench
5
Hex drive
6
Electric screwdriver
7
Tape measure
8
Ruler
18
Installation Instructions
Observe all governing codes
CUT AND Pinch Hazard
6mm (1/4'')
24mm
4mm
13mm
6mm (1/4'')
/
/
/
LOCATION REQUIREMENTS
IMPORTANT: Before use, this beverage center must
be installed properly.
NOTE: Allow the beverage center to sit upright on its
base for at least one hour before installation.
• Do not install the beverage center where the
temperature will go below 55°F (13°C) because
it will not run often enough to maintain proper
temperatures.
• Do not install the beverage center where the
temperature will go above 110°F (43°C) because it
will not perform properly.
• Install it on a floor strong enough to support it fully
loaded.
• Do not install the beverage center in a location
exposed to water (rain, etc.) or direct sunlight.
IMPORTANT: Handle with care when moving beverage
center to avoid either damaging the refrigerant tubing or
increasing the risk of a leak.
IMPORTANT: If the beverage center has been placed in
before plugging in to allow the refrigerant to settle.
Image
Toe kick supporting bracket adjustment
Measuring cabinet distance and clearances
Measuring distance of toe kick and levelness
Where used
Front leveling leg
adjustment
Front leveling leg
adjustment
Top door adjustment
Top door adjustment
Rear Roller adjustment
Installation of fasteners
49-1000777 Rev. 2
Publicité
