Yamaha Raptor 700R Manuel Du Propriétaire page 300

a
a. Spark plug gap
a. Écartement des électrodes
a. Separación entre electrodos de la bujía
Standard spark plug:
CR8E (NGK)
Installation
1. Measure the electrode gap with a wire
thickness gauge and, if necessary, adjust
the gap to specification.
Spark plug gap:
0.7–0.8 mm
2. Clean the surface of the spark plug gasket
and its mating surface, and then wipe off
any grime from the spark plug threads.
3. Install the spark plug and tighten it to the
specified torque.
Tightening torque:
Spark plug:
12.5 Nm (1.25 m0kgf)
8-51