Yamaha Raptor 700R Manuel Du Propriétaire page 292

1. Coolant reservoir cap
1. Bouchon de vase d'expansion
1. Tapa del depósito de refrigerante
1
2
2. Hose
2. Flexible
2. Manguera
8-43
5. Remove the coolant reservoir cap.
6. Disconnect the hose on the coolant reser-
voir side, and then drain the coolant from
the coolant reservoir.
7. After draining the coolant, thoroughly flush
the cooling system with clean tap water.
8. Replace the coolant drain bolt washer if it
is damaged, and then tighten the coolant
drain bolt to the specified torque.
Tightening torque
Coolant drain bolt:
10 Nm (1.0 m0kgf)
9. Connect the coolant reservoir hose.
10. Pour the recommended coolant into the
radiator until it is full.
11. Pour the recommended coolant into the
coolant reservoir to the maximum level
mark.