Suspension/Total Bending Angle Of All Bending Radii En - Abicor Binzel MasterLiner Maxi Flex/HD Mode D'emploi

MasterLiner Maxi Flex/HD; Basic Flex/HD
3.2 Suspension/total bending angle of all bending radii
CAUTION
Wire feed irregularities
Wire feed irregularities due to the lowest permissible bending radii being breached, too many bending radii and wire
feed distances exceeding 25 m.
• Please note the specifications with regard to the permissible bending angles, bending radii and maximum lengths.
 3.2 Suspension/total bending angle of all bending radii on page EN-7
• Use an additional drive in the event of wire feed distances of over 25 m.
Note how the MasterLiner is suspended!
Only use suitable suspension brackets.
Never lay the MasterLiner over sharp edges.
Wire drum
Fig. 2
Suspension/total bending angle of all bending radii
* Depending on the process and the system properties
Max. total bending angle 3x180°+1x90°
The manner in which the wire guide is laid can differ greatly. Note the individual instructions on how to correctly lay the
MasterLiner.
3.3 Abbreviations
HD
QC
Tab. 6 Abbreviations
Unit of measurement in drawings or diagrams
Tab. 7 Dimensions
BAL.0510.0 • 2021-08-19
180°/R150
180°/R150
630°
~
Heavy duty
The HD version is sheathed with durable, aramid-fibre-reinforced protective fabric
Quick connector
3 Product description
180°/R150
Max. length 25 m*
Millimetre [mm]
EN - 7