Adjusting The Bending Angle; Material Damage - Abicor Binzel WH Mode D'emploi
Marbre de contrôle et de rectification qui permet de contrôler l'orientation (angle de flexion) des cols de cygne interchangeables en dehors de la cellule de soudage
Masquer les pouces
Voir aussi pour WH:
- Mode d'emploi (101 pages) ,
- Mode d'emploi (44 pages) ,
- Mode d'emploi (109 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Alignment jig
6.2 Adjusting the Bending Angle
CAUTION
Material damage
The torch neck can be damaged in case of too frequent and excessive bending.
• Perform only minor corrections.
1
1
Test mandrel
2
Measuring sleeve
Abb. 10
Adjusting
1 Plug on/screw in the adjusting sleeve (3) onto the gas nozzle receptacle.
2 Put the adjusting lever (4) onto the adjusting sleeve (3) and correct the bending angle slightly.
Check the concentricity of test mandrel (1) and measuring sleeve (2) constantly during this procedure.
The bending angle is correct if the test mandrel (1) fits easily into the bore of the measuring sleeve (2).
BAL.0022 • 2019-04-23
2
3
3
Adjusting sleeve
4
Adjusting lever
6 Operation
4
EN - 13
Publicité
Chapitres
Table des Matières
