Wire Drum Connection - Feeding In The Wire Through An Internal Wire Guide En - Abicor Binzel MasterLiner Maxi Flex/HD Mode D'emploi

MasterLiner Maxi Flex/HD; Basic Flex/HD
6.1.1 Wire drum connection – feeding in the wire through an internal wire guide
NOTICE
• Note the minimum passage size and the permissible wire dimensions for the various MasterLiner types.
Fig. 5
Advantages
NOTICE
• If the wire ends are not close fitting, the small passage size of the MasterLiner Basic may prevent the wire from
being fed in.
Fig. 6 Wire feed
1 Push the wire end through the internal wire guide.
2 Bend the wire end over by approx. 10 mm.
 Fig. 6 on page EN-11
BAL.0510.0 • 2021-08-19
We recommend attaching a wire guide of a
suitable length to the wire drum cover.
Advantage: any dirt on the wire is removed in the wire inlet,
meaning that less dirt gets into the wire guide.
The internal wire guide can be detached if necessary and
cleaned.
Other advantages
Avoidance of
wire knots
and the wire looping round
the wire drum's components
6 Commissioning
Avoidance of contact
EN - 11