Feeding In The Wire - Abicor Binzel PP Plus 36D Mode D'emploi

PP Plus 36D/240D/401D
4.8 Setting the shielding gas
NOTICE
• The type and quantity of the shielding gas depends on the welding task and the gas
nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by impurities, the cylinder
valve must be opened briefly, before connecting the cylinder. This will blow out any
impurities that may be present.

4.9 Feeding in the wire

CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
1 Housing cover
2 Knurled screw
3 Clamp clip
Fig. 7 Feeding in the wire
BAL.0140 • 2018-10-15
1
7
4 Pressure adjustment screw
5 Wire feed roll support
4 Putting into operation
2 3
4
5
6
6 Wire feed roll
7 Seat
EN - 13