Abicor Binzel PP Plus 36D Mode D'emploi page 28

4 Putting into operation
5 Cut the PA liner (9) at the mark directly in front of the wire feed rolls by means of the
ABICOR BINZEL cutter (5).
6 Sharpen the cutting point.
4.4 Mounting the neck liner in the torch neck
The original neck liners are cut to length. The length x depends on the torch neck geometry:
1
6
5
1 Neck liner PP Plus 36D
2 Holding nipple PP Plus 36
Fig. 5 Mounting the neck liner in the torch neck
1 Remove torch neck (5) from torch seat (3) by unscrewing the nut (4).
 for PP Plus 36D
2 Screw the retaining nipple (2) onto the neck liner (1).
3 Screw the mounted neck liner (1) into the torch neck (5).
 for PP Plus 401D/240D
4 Screw the complete neck liner (6) from the rear into the torch neck (5).
5 Fasten the torch neck (5) to the torch seat (3) by means of the nut (4).
EN - 10
2
X
4
3 Torch seat
4 Nut
PP Plus 36D/240D/401D
5 Complete torch neck
6 Complete neck liner PP Plus 401D/240D
BAL.0140 • 2018-10-15
3