Replacing The Torch Neck - Abicor Binzel PP Plus 36D Mode D'emploi

8 Disposal

7.3 Replacing the torch neck

NOTICE
• Make sure that no residual coolant enters the wire conduit!
• When unscrewing the torch neck, always keep the torch handle pointing downwards.
This prevents residual coolant from seeping into the gas and wire guides.
1 Remove gas nozzle.
2 Remove welding spatter and spray gas nozzle with ABICOR BINZEL anti-spatter agent.
3 Check wear parts for visible damage and replace them, if required.
4 Replace neck liner or wire guide when worn or soiled.
NOTICE
• Grease the O-rings with silicone-free lubricant (192.0078). This makes it easier to insert
the torch neck and extends the service life of the O-rings.
5 Clean the separating point and grease O-rings with silicone-free sealing grease.
8 Disposal
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards and guidelines.
EN - 18
PP Plus 36D/240D/401D
BAL.0140 • 2018-10-15