Faults - What To Do - Gaggenau CI 292 600 Notice D'utilisation

en-us
Frequently-asked questions and answers (FAQ)
Faults – what to do?
Generally, faults are easy to remedy. Please read the
notes in the table before calling Customer Service.
Display screen
None
An audible signal
sounds.
"ƒ / "‰ƒ‹ˆ
"... / "‰ƒ‹‰
"† + heat setting and
audible signal
"† and audible signal
"‚ / "‡
"‰
"Š
"‰ƒ‹ƒ
"‰ƒ‹„
"‰ƒ‹...
"‰ƒ‹†
"‰ƒ‹‡
Do not place hot pans on the control panel.
46
Possible cause
The power supply has been discon-
nected.
The device has not been connected
according to the circuit diagram.
Electronic fault.
The control panel is damp or an object
is covering it.
The electronics have overheated and
switched off the corresponding
burner.
The electronics have overheated and
have switched off all burners.
A hot pot is in the area of the control
panel. There is a risk that the electron-
ics will overheat.
A hot pot is in the area of the control
panel. To protect the electronics, the
burner has been switched off.
The burner has overheated and
switched itself off to protect the work
surface.
The burner was operating for an
extended period without interruption.
The flex function cannot be activated.
The temperature sensor is overheated
and the burner was switched off.
The temperature sensor is overheated
and all burners were switched off.
The battery in the temperature sensor
is dead.
The temperature sensor is no longer
connected.
The temperature sensor is broken/
defective.
9
CAUTION
Repairs should only be done by an authorized
servicer.
Improper repair of your appliance may result in risk
of severe physical injury or death.
Troubleshooting
Use other electrical devices to check whether a short-
circuit has occurred in the power supply.
Ensure that the device has been connected according
to the circuit diagram.
If the fault cannot be eliminated, inform the technical
after-sales service.
Dry the control panel or remove the object.
Wait until the electronics have cooled down suffi-
ciently. Then touch any symbol on the cooktop.
Remove the pot. The fault display goes out shortly
afterwards. You can continue to cook.
Remove the pot. Wait a few seconds. Touch any con-
trol. When the fault indicator goes out, you can con-
tinue to cook.
Wait until the electronics have cooled down suffi-
ciently and switch the burner on again.
The automatic safety switch-off function has been
activated. See section
Check the fault display, to do this, touch any control.
You can continue cooking as usual with the remaining
burners. Contact the technical after-sales service.
Wait until the temperature sensor has cooled off suffi-
ciently before activating the function again.
If the temperature sensor is not being used, remove it
from the cookware and keep it far away from other
burners and heat sources. Switch the burners on
again.
Change the battery 3V CR2032. See section "Chang-
ing the battery."
Switch the function off and then on again.
Contact the technical after-sales service.