Gaggenau CI 292 600 Notice D'utilisation page 34

en-us
Automatic functions
– The battery in the temperature sensor is dead.
Reset the wireless temperature sensor and follow the
connection process once again.
If the temperature sensor and the control panel are
▯
not connected correctly due to a transmission error,
follow the connection process once again.
If no connection can be established, inform customer
service.
Resetting the wireless cooking sensor
1. Touch and hold the ¨ symbol for approximately 8-
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. At this point, you will need to lift
your finger off the symbol.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
2.
Repeat the connection process from point 2.
Programming
The cooktop must be on.
1.
Attach the temperature sensor to the cookware, see
section
2.
Place the cookware with sufficient liquid in the middle
of the desired element and always put a lid on.
3. Select the required element using the twist knob. ‹
appears in the display for the heat setting.
Press the ¨ symbol in the control panel. An audible
4.
signal sounds. The ¨ indicator lights up in the display
for the element.
Press the ¨ symbol on the wireless cooking sensor
5.
on the cookware. Once the cooking sensor has been
detected, the default temperature of 200° F (95° C)
lights up in the element display.
6.
Set the desired temperature using the twist knob. The
temperature can be changed by increments of 40° F
(5°C) .
34
7.
The element display shows the progress of the
heating process from ¬ to ª and flashes alternately
with the set temperature. Once the set temperature
has been reached, an audible signal sounds and the
heating indicator goes out. The selected temperature
will then be displayed again.
8.
Remove the lid after the signal tone and add the food.
Keep the lid closed during the cooking process.
Note: When using the fry with a lot of oil function, do
not cover the pot.
You can activate the cooking sensor function via the
wireless temperature sensor. Proceed as follows:
Place the cookware and press the ¨ symbol on the
▯
wireless temperature sensor.
Select the element using the twist knob.
▯
When the function is ready the default temperature of
200° F (95° C) is displayed.
Switching off the ccoking sensor function
You can deactivate this function in a number of ways:
Select the element and touch the ¨ symbol.
▯
Select the element and set the temperature ‹ using
▯
the twist knob.
Press the ¨ symbol on the wireless cooking sensor.
▯
A signal sounds and the ¨ symbol goes out in the
element display. The function is deactivated.