Transportation And Storage - Ryobi RFT254 Manuel D'utilisation

EN
FR DE ES IT
WARNING
Never run the wheeled trimmer without the spark
arrestor in place. Failure to do so could result in a fire
that could cause serious personal injury.
CLEANING THE EXHAUST PORT AND MUFFLER
Depending on the type of fuel used, the type and amount
of lubricant used, and/or your operating conditions, the
exhaust port and silencer may become blocked with
carbon deposits. If you notice low power from the wheeled
exhaust port and silencer for carbon deposits. Removing
the carbon deposits should restore performance to the
wheeled trimmer.

TRANSPORTATION AND STORAGE

TRANSPORTING THE PRODUCT
Drain all fuel and/or oil from tank into a container
approved for fuel. Run engine until it stops.
Set the ignition switch to the "O" (OFF) position.
Allow the engine to cool down.
For transportation, secure the machine against
movement or falling to prevent injury to persons or
damage to the machine.
SHORT TERM STORAGE
clean all foreign material from the product.
Store the product in a well-ventilated place that is
inaccessible to children.
LONG TERM STORAGE (1 MONTH OR LONGER)
Drain all fuel from tank into a container approved for
petrol. Run the engine until it stops.
Clean all foreign material from the product. Store it in
a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts. Do not store outdoors.
Abide by all ISO and local regulations for the safe
storage and handling of fuel. Excess fuel should be
used in other 2-cycle engine powered equipment.
MAINTENANCE AND STORAGE
Keep all nuts, bolts and screws tight to be sure the
product is in safe working condition.
Never store the product with petrol in the tank inside
a building where fumes may reach an open flame or
spark.
Allow the engine to cool before storing in an enclosed
space.
PT NL SV DA NO FI
English (Original instructions)
HU CS RU RO PL SL
To reduce the fire hazard, keep the engine, silencer,
battery compartment and petrol storage area free of
grass, leaves, or excessive grease.
Examine the product regularly and replace worn or
damaged parts with genuine spare parts approved
by the manufacturer. Never attempt a repair you are
not capable of, if in doubt return the product to an
authorised Ryobi repair centre.
If the fuel tank has to be drained, this should be
done outdoors. The drained fuel should be stored in
a container specifically designed for fuel storage or it
should be disposed of carefully.
Approved spare parts for the product
Replacement line 2.7 mm diameter
Pro-cut II String Head
19
HR ET LT LV SK BG
LTA050
LTA039