Starting And Stopping - Ryobi RFT254 Manuel D'utilisation

EN
FR DE ES IT
SYMBOLS
Some of the following symbols may be used on your
tool. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate
the product better and safer.
Safety alert
To avoid serious personal injury, do not
attempt to use this product until you read
thoroughly and understand completely the
operator's manual.
Beware of thrown or flying objects. Keep all
bystanders at least 15 m away.
15m
Use unleaded petrol intended for motor vehicle
use with an octane rating of 91 [(R + M)/2] or
higher.
Use 2-stroke oil for air cooled engines.
Mix the fuel mix thoroughly and also each time
before refuelling
Wear eye and hearing protection when
operating this equipment.
Do not use metal blade(s) on the product.
Keep hands away from blades.
Rotational direction and maximum speed of
the shaft for the cutting attachment.
12,000
Direction of cutting line rotation
Air filter cleaning information. Read
1 2
instructions in manual.
3
Starting a cold engine
Starting a warm engine
The two arrows should point to each other as
shown when the power head and string head
shafts are fitted together.
PT NL SV DA NO FI
English (Original instructions)
HU CS RU RO PL SL
Conforms to all regulatory standards in
the country in the EU where the product is
purchased.
GOST-R Conformity
The following signal words and meanings are intended to
explain the levels of risk associated with this product.
DANGER
Indicates an imminently hazardous situation, which, if
not avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if
not avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if
not avoided, may result in minor or moderate injury.
CAUTION
Without safety alert symbol
Indicates a situation that may result in property
damage.

STARTING AND STOPPING

To start a cold engine:
1. Set the ignition switch to the "I" (ON) position.
2. Press the primer bulb 10 times.
3. Set the choke lever to "FULL" choke position.
4. Pull the starter grip until the engine attempts to start.
Do not pull the starter grip more than 6 times. Do not
pull the throttle trigger.
5. Set the choke lever to "RUN" position.
6. Pull the starter grip until the engine starts. Do not pull
the starter grip more than 4 times.
13
HR ET LT LV SK BG