Kärcher KM 150/500 R D Classic Mode D'emploi page 25

– The oil level must lie between "MIN"
and "MAX" marking.
– Add motor oil if the oil level is below the
"MIN" marking.
– Do not fill oil above the "MAX" marking.
 Remove oil cap.
 Fill in motor oil.
For oil type refer to Chapter "Technical
specifications".
 Close oil cap.
 Wait at least 5 minutes.
 Check engine oil level.
Change the motor oil and the oil filter
CAUTION
Risk of burns due to hot engine oil!
 Allow engine to cool down.
 Prepare a collection container for at
least 6 litres of engine oil.
 Allow engine to cool down.
 Unscrew oil drain plug.
 Remove oil cap.
 Drain off oil.
1 Engine oil filter
2 Fuel filter
 Unscrew the oil filter.
 Clean the intake and sealing areas.
 Coat the washer of the new oil filter with
oil before fitting it.
 Fit in the new oil filter and tighten it by
hand.
 Screw in the oil drain screw along with
the new washer.
Tightening torque: 25 Nm
 Fill in motor oil.
For oil type and filling quantity refer to
Chapter "Technical specifications".
 Close oil cap.
 Let the motor run for approx. 10 sec-
onds.
 Check engine oil level.
Check fuel filter
 Check the fuel filter for soiling.
 Clean the fuel filter and filter casing as
needed; replace the fuel filter if neces-
sary.
Replace the fuel filter
1 Fuel cock
2 Fuel filter
 Close fuel cock.
 Unscrew the fuel filter and replace it.
1 Fuel cock
2 Fuel filter
NOTICE
Fill the fuel filter with diesel fuel prior to in-
stalling it.
 Screw the new fuel filter in.
 Torque the fuel filter to 20 Nm.
 Open fuel cock.
9
-
EN
Draining the condensation water from
the diesel water separator
1 Fuel cock
2 Separator cup
3 Water separator
 Close fuel cock.
 Unscrew the separator cup and empty
it.
 Screw on the separator cup.
 Open fuel cock.
Check hydraulic oil level and refill
hydraulic oil
NOTICE
The waste container must not be raised.
 Open engine cover.
1 Looking glass
2 Manometer
3 Screw cap, oil fill opening
 Check hydraulic oil level in the looking
glass.
– The oil level must lie between "MIN"
and "MAX" marking.
– Add hydraulic oil if the oil level is below
the "MIN" marking.
 Loosen the closing cap of the oil filling
opening.
 Clean the filling area.
 Refill hydraulic oil.
For oil type refer to Chapter "Technical
specifications".
 Replace and tighten the closing cap of
the oil filling opening.
NOTICE
If the pressure gauge shows an increased
hydraulic oil pressure, the hydraulic oil filter
must be replaced by Kärcher customer ser-
vice.
25