Publicité
All manuals and user guides at all-guides.com
SDN4520
SDN4530
4-24
BRAKE
2. Install:
•
Brake pads
•
Pad spring
Installation steps:
•
Connect a suitable hose 1 tightly to the cali-
per bleed screw 2. Put the other end of this
hose into an open container.
•
Loosen the caliper bleed screw and push the
pistons into the caliper with your finger.
•
Tighten the caliper bleed screw 2.
Bleed screw 2:
6 Nm (0.6 m • kg, 4.3 ft • lb)
•
Install the brake pads and pad spring.
NOTE:
The tangs a of the pad spring must point in the
direction of the disc rotation.
3. Inspect:
•
Brake fluid level
Refer to "BRAKE FLUID LEVEL INSPEC-
TION" in CHAPTER 2.
4. Check:
•
Brake lever operation
A soft or spongy feeling → Bleed brake
system.
Refer to "AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)" in CHAPTER 2.
POWR
TR
Publicité
