Publicité
Ski spindle camber
Place the unit on a level surface and check the ski spindle camber. DO NOT elevate the front end.
1 Using an angle finder, be sure that the unit sits parallel with the floor. Place the angle finder up against
the flat aluminum part of the belly pan.
2 Place the angle finder up against the vertical flat surface on the trailing arm just behind the spindle
weld and check the spindle camber.
Ski spindle camber:
–0.5˚ to +0.5˚
3 To adjust the camber, loosen the lower radius rod ball joint locknut and remove the bolt securing the
radius rod to the trailing arm. Turn the rod in or out as necessary until the proper camber angle is
obtained.
All manuals and user guides at all-guides.com
FRONT SUSPENSION
SDN3250
3-12
Å USE AN ANGLE FINDER TO CHECK THAT THE
UNIT IS LEVEL.
Angle finder:
YS-42422
CHAS
SDN3260
SDN3270
Publicité
