Tintometer Lovibond SD 325 Con Mode D'emploi page 47

Set output: Setting of universal output
(Out = SEr)
(Out = dAC)
(Out = dAC)
Set correction: Adjustment of measurements
(°C / °F)
(%)
SD_325_Con_1 06/2020
Universal output
oFF Interface and analogue output off
(lowest possible power consumption)
SEr Serial interface activated
dAC Analogue output activated
01.11 ... 91 Base address of the instrument
for serial interface communication
e.g. 100 µS/ Entry of the measurement value
cm at which the analogue output must
output 0V
e.g. 40 mS/ Entry of the measurement value
cm at which the analogue output must
output 1V
Zero point correction / offset of the temperature
measurement
oFF No zero point correction
-5.0 ... +5.0 Zero point correction in °C
Slope correction of the temperature
measurement
oFF No slope correction
-5.00 ... Slope correction in %
5.00
51