Thermador Professional Serie Guide D'utilisation Et D'entretien page 34

en-us Cleaning and maintenance
During the self clean cycle, parts of the appliance may
become potentially harmful to persons who lack adult
knowledge of appliances and adult reactions to potentially
harmful conditions.
Children should not be left alone or unattended in an
▶
area where appliances are in use.
The oven heats up to a very high temperature during self
cleaning. Opening the door can result in injury.
When self-cleaning, confirm that the door locks and will
▶
not open.
If the door does not lock, do not run Self Clean. Contact
▶
Customer Service.
CAUTION
Remove broiler pans, pots, and other utensils and excess
spillage before self-cleaning.
Do not leave food or cooking utensils, etc., in the oven
during the pyrolytic self-cleaning mode of operation.
CAUTION
The oven vents are important for air circulation. Covering
the oven vents will cause the oven to overheat. Refer to
the appliance overview for the location of the oven vents.
→ "Oven cavity components", Page 11
Do not obstruct oven vents.
▶
NOTICE:
Do not clean parts or accessories with the self clean
function.
Remove all accessories, racks and rack guides from the
1.
oven.
Wipe out excessive spillage from the oven cavity.
2.
Starting self clean
Requirement: You have carried out the steps for
preparing the oven for self clean → Page 33 .
Turn the mode selection knob to CLEAN MODES.
1.
Swipe to select "Self Clean"
2.
Select a cleaning intensity according to the amount of
3.
soiling.
Intensity level
high
medium
low
Turn the temperature selection knob to SELF CLEAN.
4.
Touch "Continue".
5.
The oven door locks automatically.
a
When self clean is finished, a signal sounds and the
a
appliance is turned off.
The door remains locked until the appliance has cooled
a
off.
Wipe the remaining ash from the oven with a moist
6.
cloth.
34
⁠ .
Duration (excluding cool
off)
3 hours
2½ hours
2 hours
Note: After the self clean cycle is completed, the
appliance will not allow you to start another self clean
cycle for 24 hours.
Easy clean
This function makes it easier to clean the bottom of the
oven cavity. Food and food spills are soaked and can then
be removed more easily.
Setting easy clean for the conventional oven
CAUTION
Hot steam can arise due to water in the hot oven cavity.
Never pour water into the hot oven cavity.
▶
Note: Do not open the appliance door during operation, or
the function will be interrupted.
Requirement: The oven cavity has cooled off.
Place the wire rack on level 3. Remove all other racks
1.
and accessories from the oven cavity.
Mix 2 cups of water and ½ cup of vinegar into the
2.
broiler pan and place it on the wire rack.
Turn the mode selection knob to CLEAN MODES.
3.
Swipe to select "Easy Clean" ⁠ .
4.
Touch the bottom line of the display.
5.
After a few seconds the mode starts automatically.
a
The cleaning time counts down on the display.
a
Carry out the steps for subsequent cleaning.
6.
Subsequently cleaning the oven cavity after the
cleaning function
Clean the oven cavity manually as soon as it has cooled
off after the cleaning function.
NOTICE:
Moisture in the oven cavity can cause damage to the
surfaces.
Remove remaining water from the oven cavity promptly.
▶
Do not leave the remaining water in the oven cavity for
▶
a long time, for example overnight.
Do not operate the appliance when the oven cavity is
▶
still wet or damp.
Open the appliance door and remove the remaining
1.
water with an absorbent sponge cloth.
Clean the smooth surfaces in the oven cavity with a
2.
dish cloth or a soft brush. Stubborn residues can be
removed using a soft scouring pad.
Remove limescale with a cloth soaked in vinegar and
3.
wipe it with clean water. Rub the oven cavity dry with a
soft cloth; also dry under the door seal.
Turn the appliance off.
4.
Leave the appliance door ajar in the stop position
5.
(approx. 30°) for about one hour to allow the enamel
surfaces in the oven cavity to dry thoroughly.