Thermador Professional Serie Guide D'utilisation Et D'entretien page 28

en-us Home Connect®
Food/cookware
Pies
1
Pizza
1
Potatoes, baked ,
1 2
Potatoes, mashed ,
1 2
Poultry, roasted ,
1 2
Seafood ,
1 2
Vegetables ,
1 2
Waffles, pancakes
1
Plates
Plate of food ,
1 2
Preheat cookware
1
Cover food
2
11.5 Removing the warming drawer insert
WARNING
Do not operate the warming drawer without the insert. The
heating elements will become very hot and might cause
injury.
Note: The picture show a warming drawer model with
handle. Depending on the appliance model, individual
details may differ.
Open the drawer fully.
1.
Grasp the flange of the insert about midway on each
2.
side of the drawer and lift it for approximately 2" (3 cm).
While holding the insert up rotate the front of the insert
3.
upward to clear the front inside of the drawer.
With the insert removed, the drawer base can be
4.
cleaned if necessary. Special care must be taken to
prevent any damage to the now exposed heating
element below the drawer insert.
28
12 Home Connect®
Level
Hom e C onne c t ®
medium
This appliance may be network-capable. Connecting your
Hom e C onne c t ®
high
appliance to a mobile device lets you control its functions
high
via the Home Connect® app, adjust its basic settings and
monitor its operating status.
medium
The Home Connect® services are not available in every
medium
country. The availability of the Home Connect® function
medium
depends on the availability of Home Connect® services in
your country. You can find information on this at:
medium
www.home-connect.com.
high
The Home Connect® app guides you through the entire
low
registration process. Follow the instructions in the
medium
Home Connect® app to implement the settings.
Tips
Consult the Home Connect® documents supplied.
¡
Follow the instructions in the Home Connect® app as
¡
well.
Notes
Also note the safety information in this instruction
¡
manual and ensure that it is also observed when
operating the appliance using the Home Connect® app.
Operating the appliance on the appliance itself always
¡
takes priority. It is not possible to operate the appliance
using the Home Connect® app during this time.
In networked standby mode, the appliance requires a
¡
maximum of 2 watts.
12.1 Setting up Home Connect®
Requirements
The appliance is connected to the power supply and is
¡
switched on.
You have a mobile device with a current version of the
¡
iOS or Android operating system, e.g. a smartphone.
The mobile device and the appliance are within range of
¡
your home network's WLAN signal.
Download the Home Connect® app.
1.
Open the Home Connect® app and scan the following
2.
QR code.
Follow the instructions in the Home Connect® app.
3.