Dovre VISTA 701i/V2 Installation Et Mode D'emploi page 45

Building into a new hearth
The fireplace insert is installed in two stages:
Placing and connecting the fireplace
Building up the hearth around the fireplace.
Placing and connecting the fire-
place insert
1. Place the appliance at the proper height, flat and
level.
2. If you are going to put an outsider frame around
the appliance, you should fit the included mag-
nets to the sides of the appliance; see the fol-
lowing figure.
1
2
3. Check that there is at least 15 mm of free con-
vection space between the existing walls – which
must have the necessary insulation (see chapter
"Installation Conditions") – and the back of the
appliance.
4. The masonry should not rest on the fireplace. If
required, use a support such as a steel beam.
Leave a clearance of at least 3 mm between the
support and the appliance.
4. Connect the appliance to the flue hermetically.
5. Check the draught in the flue and the seal of the
connection on the flue gas duct by making a
small, intense trial fire with newspaper and dry,
small kindling.
If there is new masonry then wait until the
masonry has dried sufficiently.
Subject to change because of technical improvements
Tapping convection air
A. Radiation
09-20024.005
B. Outflow of convection air via appliance
B'. Outflow of convection air via opening en grate
B''. Outflow of convection air from hearth mantle
C. Inflow of convection air via appliance
C'. Inflow of convection air via hearth mantle
The appliance is equipped with two additional
connections in order to transport convection heat to
other areas.There must be air grids in these areas. If
you wish to make use of this function, proceed as
follows:
B''
B'
B
A
C
C'
09-20024.012
D OVRE
15