Dovre VISTA 701i/V2 Installation Et Mode D'emploi page 41

Vista 702i/V2 and Vista 802i/V2 (vermiculite):
1
2
3
4
6
7
8
9
10
1. Convection air connection
2. Door
3. Decorative frame
4. Air slide
5. Door latch
6. Vermiculite inner side plates
7. Stove base
8. Vermiculite inner rear plates
9. Flue gas connection
10. Outside air connection
11. Magnets for the decorative frame
Subject to change because of technical improvements
5
11
09-20024.014
Features of the appliance
The appliance is supplied with a connecting kit for
the outside air supply.
The appliance is not suitable for continuous use.
The insert fireplace has an integrated convection
system. This means that when installing the appli-
ance it is not necessary for a separate convection
space to be built and the use of air inlet and outlet
grates for convection is not necessary.
The space between the hearth and the steel
convection cabinet serves as convection
space. Surrounding air is drawn in at the
bottom of the appliance. The air is directed to
the fireplace where it is heated. The heated air
then leaves the front side of the convection
space through the air opening on the upper
side of the fireplace.
The appliance is equipped with two additional con-
nections in order to transport convection heat to
other areas.
The appliance is equipped with two built-in fans
that aid convection. The turning speed of the fans
can be adjusted using a speed control. This speed
control is supplied with the appliance. The fan and
speed control are connected to the mains electric
circuit; see paragraph "Connecting fan to the
mains".
The fan works thermostatically. That
means that the fan only starts to operate if
the insert fireplace is sufficiently warm and
the fan switches off once the insert fire-
place has cooled sufficiently.
D OVRE
11