Dovre VISTA 701i/V2 Installation Et Mode D'emploi page 43

Vista 702i/V2 and Vista 802i/V2 (vermiculite):
7
12
3
9
14
13
1
1. Fire basket
2. Vermiculite side wall, right
3. Vermiculite side wall, left
4. Stainless-steel flame plate, top
5. Ash pan
6. Insulation baffle plate, L+R
7. Vermiculite baffle plate, left
8. Vermiculite flame plate, right
9. Vermiculite rear, left
10. Vermiculite rear, centre
11. Vermiculite rear, right
12. Flame plate holder
13. Left-hand stove base
14. Fire grate
15. Right-hand stove base
16. Middle stove base plate
Remove internal parts:
a. Remove the rear centre inner plate.
b. Remove right side wall inner plate.
c. Remove the flame plate holder while securing
the flame plates with the other hand.
d. Remove the right baffle plate and then the left
baffle plate.
e. Remove the rear left inner plate and side wall.
f. The stainless-steel flame plate can now be
removed (see figure below).
Subject to change because of technical improvements
4
8
6
10
11
2
16
15
5
09-20024.013
Place the parts back in the reverse order.
Connecting the fan to the mains
The fireplace insert is supplied with two built-in fans
and with a separate revolution control unit. In addi-
tion, the appliance is equipped with a thermostat
switch that switches on and off the fan at a fixed indic-
ated temperature.
The fans can be easily disconnected electrically by
the use of a plug, so that the fan plate can be
removed.
These parts must be connected to the mains accord-
ing to the connection scheme in appendix 2.
The connection diagram is specific to the
model.
Have the connection made by a qualified
installer.
The fireplace insert is provided with a three-
core cable.
The fireplace insert must be isolated from the
mains by a 2-pole switch.
Ensure that the fireplace insert is properly
earthed.
2
1
3
09-20024-025
D OVRE
13