Dovre VISTA 701i/V2 Installation Et Mode D'emploi page 44

Building into an existing
hearth
To build the stove into an existing hearth, follow the
steps below:
1. Place the appliance at the right height and level
it.
Keep the electrical cable of the appliance free.
2. If you are going to place the frame on the device,
first attach the supplied magnets to the sides of
the device as shown in the drawing.
1
2
3. Close the base of the flue with a non-combustible
material.
4. Make an opening in the base for the extraction
duct with a diameter of 150 mm (700i) or 180 mm
(800i).
5. Remove the connection collar via the inside of
the appliance.
6. Use a flexible pipe or a connection elbow of 45°.
7. Place the appliance in the opening.
8. Pull the connection pipe to the inside.
9. Attach the connection collar to the flexible pipe or
elbow.
10. Attach the connection collar back to the appli-
ance.
The following figure depicts an example of the place-
ment of a built-in fireplace in a hearth that has been
constructed according to the above instructions and
requirements.
D OVRE
14
09-20024.005
A Flue
B Connection piece
C Connection pipe
D Existing hearth
E Fireproof wall
F Ventilation space (minimum 15 mm)
G Outside air connection (back)
H Outside air connection (underneath)
I Convection air opening
J Convection air opening
K Convection air intake opening (front)
L Existing floor
A
B
C
D
E
F
G
H
Subject to change because of technical improvements
I
J
K
L
09.20024.011