Vetus ELINE050 Manuel D'utilisation page 8

ENGLISH
1 Safety
Warning indications
Where applicable, the following warning indications are used in this
manual in connection with safety:
Indicates that great potential danger exists that can lead to serious
injury or death.
Indicates that a potential danger that can lead to injury exists.
Indicates that the usage procedures, actions etc. concerned can re-
sult in serious damage to or destruction of the engine. Some CAU-
TION indications also advise that a potential danger exists that can
lead to serious injury or death.
Emphasises important procedures, circumstances etc.
Symbols
Indicates that the relevant procedure must be carried out.
Indicates that a particular action is forbidden.
Share these safety instructions with all users.
General rules and laws concerning safety and accident prevention
must always be observed.
This product should only be operated by persons who have
read and understood the instructions and precautions in this
manual. Failure to follow the instructions in this manual may
result in serious injury or property damage. The manufacturer
shall not be liable for any damages resulting from improper
operation.
8
370301.02
D
anGer
W
arninG
c
aution
n
ote
W
arninG
2 Introduction
This manual gives guidelines for the use of the VETUS E-Line electric
motor, type 'ELINE050' , 'ELINE075 and 'ELINE100' .
The E-Drive system consists of five modules:
- Propulsion
- Control
- Energy monitoring
- Energy storage
- Energy supply
Within these five modules, several options and combinations are
possible.
Please consult the user manuals of all components before using
the E-Drive system.
Unauthorised modifications shall exclude the liability of the manu-
facturer for any resulting damage.
• During use ensure the correct battery voltage is available.
Changing over the plus (+) and minus (-) connections will
cause irreparable damage to the installation.
Never work on the electrical system while it is energized.
Make sure the engine compartment is dry and well ventilated.
The installation must be kept free of bilge water at all times.
The ambient temperature should not exceed 50 °C. Ensure ade-
quate ventilation. Supply cool air and discharge warm air.
n
ote
W
arninG
W
arninG
n
ote
User manual E-Line electric propulsion