König Electronic SEC-ALARM200 Manuel page 9

All manuals and user guides at all-guides.com
Alert Mode Examples
Zone 1 Sensor 1
door open
1. Beep___ Beep___
Beep___ Beep .....
Zone 3 Sensor 2 window
open
1.
Beep Beep Beep ___
Beep Beep Beep ___
Note:
- For Door / Window sensor, alert notification (beeping and LED flashing) will continue until the sensor is in
closed position, i.e. closing the window or door.
- For Motion Sensor, the alert notification (beeping and LED flashing) will last for 20 seconds for every
detected movement.
Mute
When the alert beeping becomes undesired, you can terminate the beeping in 3 different ways:
1. Mute button - Manual mute by pressing the mute button
Pressing the mute button will temporary disable the beeping for all the activated
sensors. For example, if a window with a window sensor will be open for a long
period of time, the continuous beeping may become undesired. Pressing the
mute button will temporary disable the beeping for this sensor only, it will still
beep if other sensors are triggered. This sensor will beep again if this window is
closed, and then opened.
2. Change the buzzer mode - Disable Beeping
The beeping can be disabled for all zones by changing the buzzer mode selector.
- If the buzzer mode selector is at "I", beeping is enabled.
- If the buzzer mode selector is at "II", beeping is disabled.
If beeping is disabled, all sensor alert beeping will be disabled, however, the voice announcement and LED
flashing will still function.
3. Enable Auto-Mute in Advanced Programming
If this feature is enabled for that zone, beeping will be terminated automatically after 15 seconds. Refer to
"Advanced Programming" – "Auto Mute" on page 18 for more information on how to enable this feature.
OPERATION
2. Single flash
2. Double flash
9
Mute Button
Buzzer Mode Selector