König Electronic SEC-ALARM200 Manuel page 20

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
Learn Keychain
Additional keychain can be programmed to the control panel.
Maximum of 5 keychain can be programmed to the control panel.
- Keychain should be programmed to Device 6 to Device 0.
Follow the instructions below to program remote(s) to remote location(s) 6, 7, 8, 9, or 0, which is the bottom
row of the numeric keypad of the control panel.
Step Keys

1 [PROG]
[MPIN]

2 [4]

3 [6] to [0]

4 Activate the
remote by
pressing any
one of the
buttons
ZONE LED DESCRIPTION
Off Zone is not occupied by any remote
Flashes This zone is occupied by another remote. Programming another remote to this zone will
twice overwrite the previous remote.
** Table A: Zone LED status for learning keychain.
ZONE LED REMOTE LOCATION
1 6
2 7
3 8
4 9
5 0
Function Description
Enter Programming Enter master password
to programming mode
mode
Select learn remote
programming
Select remote Select a remote
location (Max. 5 location [6], [7], [8], [9]
remotes or [0].
Trigger remote Once the signal is
transmitted to the
Control Panel, that
signal which will be
stored.
Romote [6] is represented by zone LED 1
20
Note
3 beeps for valid password.
1 long beep for invalid
password.
After [4] is entered, some
zone LEDs will flash or stay
off. The zone LEDs
represent whether that zone
is already occupied by
another remote
** See Table A below.
After you have selected the
remote location, that zone
LED will be on.
You will hear [Device X
Accepted], where "X" is the
remote location.