König Electronic SEC-ALARM200 Manuel page 3

All manuals and user guides at all-guides.com
Installing the Console
You must first determine where the control panel will be located. Please follow the criteria below to select the
ideal location for the control panel.
- Place it within a few feet of an electrical outlet and phone jack
- Place it where it is easily accessible by you and other users
- Place it away from any doors or windows which could be accessed by non-intended users
- Place it away from extreme temperature sources such as oven, stove and away from large metal objects
which could affect the wireless performance.
After you have selected a location for the control panel, you are now ready to connect all the necessary wires
and ready to power up the unit.
1. Plug in the AC adapter to a nearby electrical outlet and plug the
other end to the socket labeled "DC 12V" on the back of the
control Panel. You should hear 3 beeps and "System Phone
Failure" indicating the phone line is not connected. PWR, ARM
and PROG LEDs should be flashing, LO BATT LED should be
on.
2. Remove the battery cover on the bottom of the control panel with
a Phillips screw driver, and insert 4 AAA alkaline batteries into
the battery holder (note the polarity). After inserting the batteries,
the LO BATT LED should be off.
3. Connect the phone line from the telephone jack to the back of
the control panel where it marks "LINE". PWR will stay on and
PROG LED will stop flashing.
4. [OPTIONAL] If you have another telephone that will be using the
same telephone jack, you may connect this telephone to
"PHONE" outlet of the the control panel by a phone cord. (not
provided).
5. Rotate the antenna to the upright position to ensure the best
signal reception.
6. For models with multiple languages select the desired language
based on the setting below.
[ 1 ] - German
[ 2 ] - Spanish
[ 3 ] - French
[ 4 ] - English
INSTALLATION
3
4
3
2
Language
selector
1