König Electronic SEC-ALARM200 Manuel page 11

All manuals and user guides at all-guides.com
3. When the exit delay expires, the control panel will announce "System Armed", beeping will stop and the
ARM LED will be on steadily. This indicates the system is now armed.
Note:
The control panel can also be armed remotely when nobody is home, with a touch tone phone. Please refer to
"Remote Operation by Telephone" on page 14.
Disarming the system
If a sensor is triggered while the control panel is armed, such as entering a house with an armed control panel,
an entry delay will be triggered. User is allowed to disarm the control panel during the 30-second entry delay.
If the control panel is not disarmed within 30 seconds, siren will sound immediately and emergency calls will
be made. To disarm the control panel, follow the instructions below.
Exit delay 30 seconds
Arm LED flashes
Beep Beep
1. Entering the premises will 2. Enter password within 30
trigger the entry delay.
1. During the entry delay, the system will beep for 30 seconds, the ARM LED will flash during this entry delay
interval. The faster the beep, the less time you have left to disarm the control panel before the siren
sounds.
2. You must enter a valid password, either the Master Password, or Secondary Password to disarm the
system before entry delay expires. The system can also be disarmed by pressing button 3 on the keychain
remote.
3. When a valid password is entered, you will hear "System Disarmed" and the entry delay beeping will stop,
the ARM LED will be off.
Note:
- The control panel can also be disarmed remotely when nobody is home, with a touch tone phone. Please
refer to "Remote Operation by Telephone" on page 14.
- If 3 consecutive incorrect passwords are entered, alarm will sound immediately, the control panel will be in
panic mode, and start calling the emergency phone numbers.
Disarming a triggered control panel
If "System Panic" is announced from the control panel after it has been disarmed, that means the alarm was
triggered when it was in armed mode. Follow the procedures below to set the control panel back to standby
mode.
1. If the alarm was caused by sensor(s), there will be flashing LEDs and beeping indicating which sensor(s)
triggered the alarm. You may want to check the condition of the triggered sensor(s), the sensor(s) may be
damaged if there were break-ins.
OPERATION
OR
Beep Beep
3. Once the system is
seconds or press the disarmed, the Arm LED
disarm button on the will be off.
keychain remote.
11
Arm LED off
System
Disarmed