König Electronic SEC-ALARM200 Manuel page 5

All manuals and user guides at all-guides.com
Step Keys

1 [MPIN] Enter
[PROG] Programming
mode

2 [1] Select phone
number
programming

3 [1] to [5] Enter phone
memory

4 [Phone Enter phone
number] + number
[Arm]

5 [1] to [9]+ Enter Redial count
[Arm]

6 [1] to [9] + Enter Repeat
[Arm] count
**Note:
You may enter a 3-second pause between digits by pressing [Mute] if needed. You may also enter
consecutive multiple pause periods. For example, you may enter a phone number: (123)-456-7890 [Mute]
1234. After the phone number (123)-456-7890 is dialed, it will wait for 3 seconds, then dial 1234, which can be
a password to a paging system, or an access code for a phone dialing system.
Note:
- It's not recommended to program 911, fire station or any emergency services phone numbers into any of the
phone memories without their approvals.
- Ensure to program a valid phone number and write down the programmed phone number on the System
Setting Information provide on the back of this user's instructions.
- You may quit programming by pressing [PROG] button at any time.
- If no phone number is programmed, the ARM LED will continue to flash.
Testing Phone Numbers:
After you have programmed all the phone numbers, you should verify you have programmed the phone
numbers correctly. This can be done by triggering the alarm silently by entering the duress password, so it
dials to the programmed phone numbers without sounding the alarm.
Note:
You must inform the recipients of the programmed phone numbers, so they know what to expect when they
receive the phone call from the control panel during an emergency. These recipients should know the
password to your control panel if you expect them to have remote access of your control panel. For more
information regarding receiving the emergency call, please refer to page 14.
INSTALLATION
Function Description
Enter master password to
programming mode
During emergency, phone
memory 1 will be called first,
then phone memory 2, 3, 4,
and 5. So phone memory 1
has higher priority.
Phone number can be up to
29 digits**
Redial is the number of times
that phone number will be
called. Each phone number
can have a different redial
count, from 1 to 9 times.
Repeat is the number of times
that voice emergency
message will be played, from
1 to 9 times. It is
recommended to set up the
repeat time to 5 or more.
5
Note
3 beeps for valid
password. 1 long beep
for invalid password.
You will hear [Enter
phone memory].
You will hear [Enter
Redial].
You will hear [Enter
Repeat].
You will hear [Phone
Accepted] indicating
the phone number and
its settings have been
programmed
successfully.