König Electronic SEC-ALARM200 Manuel page 16

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
Programming Summary
COMMAND
[PROG] + [1]
[PROG] + [2]
[PROG] + [3]
[PROG] + [4]
[PROG] + [5]
[PROG] + [6]
[PROG] + [7]
[PROG] + [8]
[PROG] + [9]
Follow the instructions below to have access to Advanced Programming.
Beep / Alarm
User can customize the audio warning so that when a sensor is triggered, the control panel may beep or
alarm may sound instantly. Depending on whether the control panel is armed or disarmed, the audio warning
is different.
System Disarmed (Alert Mode)
If a zone is set to "Beep", the control panel will beep when a sensor is triggered, until the sensor is deactivated.
Motion Sensor activation will not cause any beeping unless the zone for the motion sensor is programmed as
a "Bypass Zone" (see page 19)
If a zone is set to "Alarm", alarm will sound instantly when a sensor is triggered.
Alarm will stop when the sensor is deactivated, or reaches a 3-minute time out period.
System Armed (Alarm Mode)
If a zone is set to "Beep", the control panel will give entry / exit delay.
If a zone is set to "Alarm", the siren will sound immediately without entry delay
- Alarm Mode (System Armed): If a sensor is triggered (i.e. opening a door) with the alarm setting on, the
siren will sound immediately without entry delay, it is called "Instant Alarm". The siren will not stop until the
siren timeout or a valid password is entered. Control panel will call the emergency phone numbers to notify
the users of the alarm situation.
When a sensor is triggered, there are 4 options:
OPERATING MODE
Disarmed (Alert)
Armed (Alarm)
DESCRIPTION
Program Phone Numbers
Program Password
Learn Sensors
Learn Keychain
Beep / Alarm Setting
Auto Mute Setting
Alert Zone (Bypass) Setting
Erase Sensors
Erase Keychain or Keypad Transmitters / Control Modules
ZONE SETTING
BEEP
1) Beep
3) Entry / Exit Delay
16
ALARM
2) Alarm sounds immediately
4) Alarm sounds and calls
preprogrammed phone numbers
immediately