König Electronic SEC-ALARM200 Manuel page 15

All manuals and user guides at all-guides.com
There are 2 ways you can have access to the remote phone operation:
1. You can call the control panel when you are away from home; or
2. When the control panel calls you during emergency.
To access the control panel away from home
Calling in when you are away from home
1. Call your home phone number, or the number that the phone line of the control panel is connected to.
2. Hang up after the second ring.
3. Wait at least 10 seconds, but not more than 40 seconds, then call the phone number again.
4. The control panel will pick up the phone call and request for a valid user password, you will hear "Enter
Password". You can enter either the Master Password or Secondary Password. If the password is correct,
you will hear "Password Accepted", otherwise, you will hear "Password Failure".
5. Once the password is accepted, you can have access to all the operations listed below.
Table 1: Remote Phone Operations
SYSTEM OPERATION
Check system status
Arm
Disarm
Disconnect
Advanced Programming allows users to customize the control panel to react differently under different
conditions. Features such as:
- When a sensor is triggered, the control panel can beep or alarm
- Beeping can be terminated automatically after a fixed period of time for some sensors
- Some sensors can be programmed to beep only, never alarm
- When a door is open, turn lights on
- Program additional sensors and remotes
COMMUNICATION
PHONE COMMAND
[8]+[#] You will hear system status announcement
[7]+[#] You will hear [System Armed]
[9]+[#] You will hear [System Disarmed]
[0]+[#] Phone line disconnect
15
DESCRIPTION