König Electronic SEC-ALARM200 Manuel page 24

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
ZONE LED DESCRIPTION
Off Zone is not occupied by any sensor
Flashes once This zone is occupied by sensor 1.
Flashes twice This zone is occupied by sensor 2.
Flashes once, then This zone is occupied by sensors 1 and 2.
twice
** Table D: Zone LED status for erasing sensors.
Control Panel
Questions
Why I can't arm my system?
I cannot arm the system even when no sensor
is triggered, and the ARM LED is off.
Why the ARM LED keeps flashing?
How do I exit programming mode when I'm in
the middle of it?
When a sensor is triggered, the alarm sounds
instantly even it is not armed, why is that?
When the alarm is triggered, why the control
panel won't call all the programmed phone
numbers? It always stops before calling the
last number.
Why the control panel doesn't beep when a
sensor is triggered, while only the zone LED
flashes?
The control panel is in armed mode, why
activating a sensor will not cause an alarm, or
call any emergency phone number?
TROUBLE SHOOTING
Make sure none of the sensors are triggered. You can
check this by the zone LEDs, none of them should blink.
You need to disarm the system again by either entering
the password or disarm by keychain remote. Although the
ARM LED is off, but the system is not completely
disarmed after an alarm was triggered. Refer to page 11
on how to completely disarm a control panel after an
alarm has been triggered.
That means you have not programmed any emergency
phone numbers. For instructions on how to program
emergency phone numbers, please see page 4.
You can press the programming button on the side of the
unit to quit programming anytime.
You have programmed that sensor in alarm mode, instead
of beep mode. Please refer to page 16 for instructions of
how to program it back to beep mode.
The control panel will stop calling when it is disarmed by
any one of the recipients. Disarm can also be done locally
thru the keypad on the control panel by entering a valid
password.
You have placed the buzzer mode selector on the side of
the control panel to "II", this will disable the beeping.
Placing it to "I" will enable the beeping.
If the triggered sensor is programmed in the Alert Zone
(Bypass Zone), alarm will not sound, and emergency call
will not be made if this sensor is triggered. The control
panel will only respond when it is disarmed, in alert mode.
24
Solutions