König Electronic SEC-ALARM200 Manuel page 25

All manuals and user guides at all-guides.com
Sensors
When a sensor is triggered, the control panel
doesn't respond at all, what is the problem?
My motion sensor sometimes gets triggered by
itself, how can I prevent that?
After mounting the door sensor, it doesn't work
anymore.
My motion sensor is not very responsive,
sometimes when I walk by it, the control panel
doesn't respond, but sometimes it does.
TROUBLE SHOOTING
- Make sure the battery in the sensor is installed
properly, pay attention to the polarity
- Make sure the sensor is learned to the control panel.
Follow instructions on page 21 on how to learn a
sensor.
- You may try to bring the sensor closer to the control
panel, ensure it is not out of the operation range.
Ensure the motion sensor is not facing direct sunlight,
nor any A/C or furnace vents. You may also reduce the
sensitivity to low. If your motion sensor is located
outdoors, you may want to relocate it.
- Please ensure the magnet is aligned with the red
marking on the transmitter.
- If you are mounting the sensor on to a metal door or
window, a spacer may be required to avoid magnetic
interference caused by the metal door / window.
- Make sure the sensor is within the operation range of
the control panel by bringing it closer to the control
panel.
The motion sensor is designed to detect the "First
Motion". First Motion means no motion is detected within
the past 20 seconds, and if a motion is then detected,
that is the "First Motion". So if you continue to walk in
front of the motion sensor, it will only pick up the first
motion. Unless you wait for 20 seconds, then walk again,
the control panel will respond. Otherwise, the control will
only respond to the first motion.
25