König Electronic SEC-ALARM200 Manuel page 21

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
Erase Keychain / Keypad Remotes
Step Keys

1 [PROG]
[MPIN]

2 [0]

3 To erase an
occupied
remote, press
[6] to [0].
ZONE LED DESCRIPTION
Off Zone is not occupied by any remote
Flashes This zone is occupied by a remote. You msy select this zone to erase this remote.
twice
** Table B: Zone LED status for erasing keychain remote(s).
Learn Sensors
You can program up to 10 sensors to the control panel. There are 5 zones on the control panel, each zone
can program up to 2 sensors. Before programming a sensor, you must decide which sensor location (zone
number and sensor number) you would like to program the sensor to. It is strongly recommended that you
refer to "Sensor Location Selection Guide" before deciding which sensor location you would like to program
the new sensors to. Some features you may need to consider are: 1) Beep/Alarm setting, 2) auto mute, 3)
alert zone, Explanation for each feature can be found in the following pages in Advanced Programming:
1. Beep/Alarm Setting - Page 16
2. Auto Mute - Page 18
3. Alert Zone - Page 19
Sensor Location Selection Guide
You can program up to 10 sensors to the control panel. There are 5 zones and maximum 2 sesnors per zone.
The 4 features mentioned above are Zone dependent features meaning both sensors in that zone will operate
based on the setting for that zone. So if you program 2 sensors into one zone, those 2 sensors will react in the
same manner for those zone dependent features. For example, if you enable the Auto-Mute feature for zone 1,
both zone 1 sensor 1, and zone 1 sensor 2 will have this feature enabled. It is not possible to enable a zone
dependent feature for sensor 1 only, but not sensor 2.
Therefore, the followings are some suggestions of how you should select the sensor location.
Function Description
Enter Programming Enter master
mode password to
programming mode
Select erase remote
programming
Select remote Select a remote
location you would location [6], [7], [8],
like to erase [9] or [0].
21
Note
3 beeps for valid password. 1
long beep for invalid
password.
After [0] is entered, some zone
LEDs will flash or stay off. The
zone LEDs represent whether
that zone is occupied by any
remote.
** See Table B below.
After you have selected the
remote location, you will hear
3 beeps and verbal
confirmation [Device X Empty
Memory], where X is the
remote location you have
selected.