König Electronic SEC-ALARM200 Manuel page 18

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
Auto Mute
When a sensor is triggered in alert mode, audio warning will be emitted, either beep or alarm. For example, if
a door is opened, the beep will not stop until the door is closed. If the door is open for 2 hours, the beep will go
on for 2 hours. There are times that this is not desired. With the auto mute feature enabled, the beep will go
on for only 20 seconds. After that, even if the sensor remains open, the beep will stop only the zone LED will
flash to indicate the sensor is triggered. Beep will go on again if the sensor is closed and opened again.
Note: Auto Mute only functions when the control panel is in alert mode (disarmed). If the control panel is in
alarm mode (armed), a triggered sensor will result in entry delay or instant alarm.
Factory Default: This feature was disabled for all zones at the factory.
To enable auto mute feature, follow the instructions below.
Step Keys

1 [PROG]
[MPIN]

2 [6]

3 Disable
Auto Mute:
[1] to [5]

Enable Auto
Mute:
[6] to [0].

4 [PROG]
when
finished.
DISABLE
AUTO MUTE
Zone 1 Button [1]
Zone 2 Button [2]
Zone 3 Button [3]
Zone 4 Button [4]
Zone 5 Button [5]
Function Description
Enter Programming Enter master
mode password to
programming mode
Select Auto Mute
Enable / Disable
Select which zone Refer to the diagram
you would like to below to select the
enable / disable appropriate setting.
auto mute.
Terminate
programming mode.
ENABLE
AUTO MUTE
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
18
Note
3 beeps for valid password. 1
long beep for invalid
password.
After [6] is entered, some
zone LEDs will flash or stay
on. This indicates whether
Auto Mute is enabled or
disabled.
If auto mute is enabled, that
zone LED will be on. If it is
disabled, the LED will flash.
You are allow to make
multiple changes before
terminating programming
mode.
PROG LED will be off, and
you will hear 3 beeps.
This row:
Buttons to disable Auto Mute
Zone LED: Flash
This row:
Buttons to Enable Auto Mute
Zone LED: ON