König Electronic SEC-ALARM200 Manuel page 17

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
Factory Default: All zones were programmed to Beep at the factory.
Caution:
It is not recommended to program an outdoor sensor to Alarm mode, which may cause false alarm. For
outdoor sensors, they should be programmed into an Alert Zone, please refer to page 19 for details.
Follow the procedures below to program the beep / alarm setting.
Step Keys

1 [PROG]
[MPIN]

2 [5]

3 Set to Beep:
[1] to [5]

Set to Alarm:
[6] to [0].

4 [PROG] when
finished.
BEEP
Zone 1 Button [1]
Zone 2 Button [2]
Zone 3 Button [3]
Zone 4 Button [4]
Zone 5 Button [5]
Example:
If you would like to change the setting for zone 5 from "Beep" to "Alarm", simply press [0] at step 3.
This will change the zone 5 setting to "Alarm".
Function
Enter Programming Enter master
mode password to
programming mode
Select Beep / Alarm
Setting
Select which zone Refer to the diagram
you would like to below to select the
Beep or Alarm. appropriate setting.
Terminate
programming mode.
ALARM
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
17
Description
3 beeps for valid
password.
1 long beep for invalid
password.
After [5] is entered, some
zone LEDs will flash or
stay on. This indicates
whether that zone is set to
beep or alarm.
If Alarm is set for that
zone, that zone LED will
be on. If Beep is set, the
LED will flash. You are
allowed to make multiple
changes before
terminating programming
mode.
PROG LED will be off,
and you will hear 3 beeps.
This row:
Buttons for Beep
Zone LED: Flash
This row:
Buttons for Alarm
Zone LED: ON
Note