König Electronic SEC-ALARM200 Manuel page 22

All manuals and user guides at all-guides.com
ADVANCED PROGRAMMING
1. Check all the zone dependent features, and determine if you would like to enable any one of them.
2. If you decide not to enable any zone dependent features and keep the factory default setting, you can
simply program the sensor to any sensor location based on your own preference. Omit the following steps
and proceed to "Learn Sensor - Continue".
3. If you decide to enable some of the zone dependent features, check Table C below. Circle the zone
dependent feature selections. If there are features that you would like to enable for more than 2 sensors,
you need to select more than one zone for those features.
zone 1
zone 2
zone 3
zone 4
zone 5
Table C
4. Once you have filled out the table, it should look something like this
SENSOR 1
Location
zone 1
zone 2 Kitchen Motion
zone 3 Back Door
zone 4 Backyard Motion
zone 5
You may refer to each column representing the zone dependent feature, to program each zone with the
selected feature. For example, Auto Mute feature is only enabled for zone 3, when you are in the auto mute
programming, you should enable this feature for zone 3 only, the rest of the zones should have this feature
disabled. Repeat this step for all 4 zone dependent features during programming.
5. You may now follow the procedure below "Learn Sensor Continue" to program the sensor(s) to the desired
zone(s).
Learn Sensors – Continue
Step Keys

1
[PROG] Enter Programming
mode
[MPIN]

2 [3] Select learn sensor
programming
Beep / Alarm
Beep / Alarm
Beep / Alarm
Beep / Alarm
Beep / Alarm
SENSOR 2
Location Beep / Alarm
Beep / Alarm
Beep / Alarm
Beep / Alarm
Beep / Alarm
Beep / Alarm
Basement Motion
Function Description
Enter master password
to programming mode
22
Y / N Disabled / On / Off
Y / N Disabled / On / Off
Y / N Disabled / On / Off
Y / N Disabled / On / Off
Y / N Disabled / On / Off
ZONE DEPENDENT FEATURES
Auto Mute Alert
Y / N
Y / N
Y / N
Y / N
Y / N
3 beeps for valid password. 1
long beep for invalid
password.
After [3] is entered, some zone
LEDs will flash once, or twice,
some will be off. The zone
LEDs represent whether that
zone is already occupied by
another sensor.
**See Table D next page.
Alert
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Y / N
Note