Homelite HBL26BVB Manuel D'utilisation page 19

EN
FR DE ES IT
or damage occurred during shipping.
Do not discard the packing material until you have
care fully inspected and satisfactorily operated the
product.
ASSEMBLING THE BLOWER TUBES
Insert one end of the lower tube into one end of the
upper tube.
Align raised tabs on blower housing outlet to the slots
on upper tube; slide together and tighten securely by
twisting; press slider plate into positive switch's slot to
allow the positive switch to engage and be ready to
work. Check tightness after initial use and retighten if
needed.
Close the inlet cover and tighten the screw on the
cover, making sure the metal contact is inserted into
the positive switch.
Pull out the slider from positive switch, then rotate the
tubes to remove them from the blower housing outlet.
INSTALLING THE VACUUM BAG
Remove blower tube from the blower by pulling off the
metal contact, twisting and removing from the blower
housing outlet.
Unzip the vacuum bag and place the adaptor inside
as shown. Push the vacuum bag adaptor through the
adaptor will remain on the inside of the vacuum bag
when installed properly.
Align the raised slots on the vacuum bag adaptor with
the raised locking tabs on the blower housing outlet;
into place, press the metal contact into the positive
switch slot to make sure the switch is engaged and
ready to operate.
Rotate the vacuum bag until the shoulder strap is
upright.
Make sure the vacuum bag is zipped and closed
before starting the unit.
INSTALLING THE VACUUM TUBES
PT NL SV DA NO FI
English (Original instructions)
HU CS RU RO PL SL
Rotating impeller blades can cause severe injury.
Always stop the engine and ensure impeller blades
have stopped rotating before opening the vacuum
door or installing/changing tubes. Do not put hands or
any other object into the vacuum tubes while they are
installed on the unit.
To install the vacuum tubes:
Secure the upper and lower vacuum tubes together
by aligning the raised locking tabs with the matching
orifice on the upper vacuum tube, the two tubes
become one tube after inserting them together, it is
once time assembly.
Depress door tab using a flathead screwdriver and
loosen the screw on the door to open vacuum inlet
door.
Align tabs on housing with tube assembly.
blower housing. Make sure the metal contact on the
vacuum tube is inserted into the positive switch.
To remove the vacuum tubes:
Loosen screws of the upper vacuum tube by turning
counterclockwise.
Remove the vacuum tube assembly from the blower
housing.
Close the vacuum inlet cover door securely by
fastening the screw on the door.Make sure the metal
contact on the vacuum tube is inserted into the positive
switch.
OPERATION
NOTE:
both the metal contacts are inserted into the positive
the metal contact on the blow tube and the door must
be inserted into their respective positive switches. When
vacuuming mode, the metal contact on the adapter tube
and the vacuum tube must be inserted into their respective
positive switches.
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
17
HR ET LT LV SK BG
WARNING
WARNING