Scheppach HP3000S Traduction Des Instructions D'origine page 30

• Carefully press the machine forward using the steer-
ing bar (8) so that it is on the front edge of the base
plate (7) and slide the wheel kit under the base plate
(7).
• The wheel kit must be locked into the place with the
locking hook in the base plate hole (7).
• The machine can now be moved using the steering
bar (8)
The wheel kit is disassembly in reverse order.
m Attention: Only use the wheel kit on a level and sol-
id surface and for short distances.
Paving Pad Kit (fig. D)
The transparent rubber paving pad allows to compact
concrete slabs, stones, bricks and blocks silently and
gently.
Attach the paving pad onto the base plate (7) as shown.
Align the holes in the base plate, paving pad and clamp
plate, and secure it with bolts and flat washers.
Engine oil (fig. E)
m Check engine oil before commissioning!
9. Commissioning
m ATTENTION!
Always make sure the device is fully assembled
before start-up!
Hand Grip (fig. A)
When operating the compactor, use this hand grip (3)
to maneuver the compactor.
Shift Stick (fig. A + F)
Push the stick (1) forward, the compactor will move in
a forward direction. Pull the stick (1) backwards, the
compactor will move in reverse direction.
Throttle Control (fig. A)
The throttle lever (2) controls engine speed. Moving the
throttle lever (2) in the directions shown makes the en-
gine run faster or slower.
langsam schnell
Fast =
vitesse lente vitesse rapide
Slow = langsam schnell
vitesse lente vitesse rapide
slow fast
slow fast
Pomalu rychle
Pomalu rychle
Pomalý rýchly
30 | GB
Pomalý rýchly
Počasnega hitrega
Handlebar (fig. A)
When operating the compactor, this handle (8) is to be
in the downward position. When the compactor is to be
stored, move the handlebar (8) to the upright position.
Handlebar Latch Pin (fig. G)
Used to lock the handlebar (8) in place in the upward
position for transporting and stowing.
Press the steering bar (8) forward and lock it with the
adjustment bolt.
Lift Point (4) (fig. A)
Used to lift the machine with crane or other lifting de-
vice.
Belt Guard (fig. H)
Remove this guard to gain access to the V-belt. Nev-
er run the compactor without the V-belt guard. If the
V-belt guard is not installed, the possibility exists that
your hand may get caught between the V-belt and
clutch, thus causing serious injury and bodily harm.
Exciter
An eccentric weight mounted on the exciter shaft con-
tained within exciter housing is driven at high speed by
a clutch and belt drive system. This high speed shaft
revolution causes the rapid lifting and downward ram-
ming motion of the machine as well as imparting a for-
ward motion.
Engine switch (fig. A)
The engine switch (21) enables and disables the igni-
tion system. The engine switch (21) must be in the ON
position for the engine to run.
Turning the engine switch (21) to the OFF position
stops the engine.
Running the engine with dirty oil can cause premature
engine wear and failure.
Changing oil regularly is extremely important.
Oil Drain Hoe (fig. L)
Running the engine with dirty oil can cause prema-
ture engine wear and failure. Changing oil regularly
is extremely important. The flexible oil drain hose is
equipped to drain oil into appropriate receptacle.
Check before operation
Check
Look around and underneath the engine for signs of oil
or gasoline leaks.
www.scheppach.com