Information On Safety; Intended Use; Predictable Incorrect Application - Daikin RoCon UFH Manuel D'installation Et De Fonctionnement

2.2

Intended use

This product may only be used to control the room temperature (heat/cool) of individ-
ual rooms with underfloor heating system.
The controller modules may only be used to control the thermostatic actuators via the
signals of the associated room controllers and the base module.
Any use other than the application explicitly permitted in these operating instructions
is not permitted and causes hazards.
Verify that the product is suitable for the application planned by you prior to using the
product. In doing so, take into account at least the following:
• All directives, standards and safety regulations applicable at the installation site of
the product
• All conditions and data specified for the product
• The conditions of the planned application
In addition, perform a risk assessment in view of the planned application, according
to an approved risk assessment method, and implement the appropriate safety meas-
ures, based on the results of the risk assessment. Take into account the conse-
quences of installing or integrating the product into a system or a plant.
When using the product, perform all work and all other activities in conjunction with
the product in compliance with the conditions specified in the operating instructions
and on the nameplate, as well as with all directives, standards and safety regulations
applicable at the installation site of the product.
2.3

Predictable incorrect application

The product must never be used in the following cases and for the following purposes:
• Hazardous area (EX)
- If the product is operated in hazardous areas, sparks may cause deflagrations,
fires or explosions
• In conjunction with products which are used for health-saving or life-saving pur-
poses or whose operation may incur hazards to humans, animals or property

Information on safety

RoCon UFH
EN
4